Spectral edit parametric EQ
Depending on how the track is displayed and what spectral selection has been made, this effect will do one of the following:
- When the track is not in Spectrogram View with Spectral Selection enabled, an error message will be displayed
- When the spectral selection has a center, upper and lower frequency this effect performs a band cut or band boost according to the value entered in the "Gain (dB)" control. The center frequency is defined by the center frequency of the spectral selection and the bandwidth is defined by the upper and lower frequencies of the spectral selection.
- When either the upper or lower frequency boundary is undefined, an error message will be displayed to that effect. If the lower frequency boundary is 0 Hz there is no center frequency or bandwidth and an error message will state that the lower frequency must be above 0 Hz.
|Due to a limitation in Nyquist effects, the effect dialog will be displayed before any error message.|
Clicking on the command buttons give the following results:
- Manage presets gives a dropdown menu enabling you to manage presets for the tool and to see some detail about the tool. For details see
- plays a short preview of what the audio would sound like if the effect is applied with the current settings, without making actual changes to the audio. The length of preview is determined by your setting in , the default setting is 6 seconds.
- applies the effect to the selected audio with the current effect settings and closes the dialog
- aborts the effect and leaves the audio unchanged, closing the dialog
- brings you to the appropriate page in the Manual, this page
In the following example the spectral selection had a center frequency of 2000 Hz and a bandwidth of 2 octaves. In the Spectral edit parametric EQ dialog, the Gain was set to -20 dB.
In the following example the spectral selection had a center frequency of 2000 Hz and a bandwidth of 2 octaves. In the Spectral edit parametric EQ dialog, the Gain was set to +10 dB.